Fleet Manager 100 English
1. Operation in the vehicle
Driver log-on and enablement of the on-board computer
To log on as a driver, insert your blue driver key into the reader
unit in the vehicle. The on-board computer will beep twice
briefly and the LED in the reader unit will go out. Your driver
I.D. has then been loaded, and you can start the vehicle. If the
LED continues to flash, log-on has failed or you have no access
entitlement for the vehicle. The entitlement can be stipulated
with the Fleet Manager software.
Data transfer
For data transfer, insert the green vehicle key into the reader
unit in the vehicle.
The on-board computer beeps briefly and starts transferring the
data. During transfer, the LED in the reader unit flashes rapidly.
When data transfer is complete, a brief acoustic signal sounds
and the LED starts flashing in a one second rhythm again.
Only the data which has been added since the last time the key
was read is transferred, and the time between the two acoustic
signals can therefore be very short.
Should an error occur during data transfer (e.g. key is full), it is
identified by an acoustic code. Please consult the notes in the
following chapter.
To Next Page
Loading...
Need help?
General