MANN + HUMMEL ProVent
MANN+HUMMEL Industrial Filters 6
Pos. Name Pos. Name
1 Lid with integrated pressure control valve 8 Outlet
2 Oil separating element 9 Seal of blow-by inlet
3 Housing 10 Seal of lid/housing
4 Pressure relief valve/bypass valve 11 Pressure control valve
5 Holder 12 Seals of element
6 Oil return 13 Quick-connect couplings
7 Inlet 14 Lid with integrated pressure relief valve
4 Assembly
4.1 General information
Check that the scope of delivery is complete
and that there are no signs of damage.
If parts delivered are damaged, please inform
MANN+HUMMEL immediately.
The assembly of the ProVent and the
installation of the lines may only be
carried out by qualified persons
instructed for this purpose.
It is essential to observe the
information on correct assembly when
completing assembly and installation
work.
When working on the fuel supply,
always place collecting vessels under
the tank or lines to collect any
escaping fuel. Dispose of collected
fuel or oil in accordance with the
respective applicable local waste
disposal directives.
Pay attention to the direction of flow.
Carry out fixations conscientiously.
Health hazard due to escaping oil!
Wear safety goggles and gloves.
(Also refer to the material safety data
sheet for diesel fuel)
To Next Page
Loading...
