USER’S MANUAL
39
‘’Blue’’ key again to cancel it. Press ‘’MENU’’ key to return
main menu.
Favourite: After choosing channel press ‘’Yellow’’ key,
Favourite icon appears behind the channel which you select,
press ‘’Yellow’’ key again to cancel it. Press ‘’MENU’’ key
to return main menu
Press the ‘’MENU’’ key, CHANNEL menu shows on the
screen. Press ‘’Up/Down’’ key to select Signal Information.
Press ‘’OK’’ key to enter into Signal Information menu.
You can look through signal information.
CI Information
Press the ‘’MENU’’ key, CHANNEL menu shows on the
screen. Press ‘’Up/Down’’ key to select CI Information. When
you insert the CI card, press ‘’OK’’ key to enter into CI Infor-
mation menu. You can look through CI information.
Note:
Before you press the MENU button, please select the
input source rst. Only in DTV and ATV mode you can
change it.
Open or close software update function by pressing „OK”
key on the remote control.
Select Channels with „CH+/CH-” Key
Press Program key on the remote control or „CH+/CH-”
key on the panel to select the channels.
Select channels with the Return key : you can go to the
last channel when pressing the Return key. For example, if
the last channel is 10 and the current channel is 20, you will
go to channel 10 when pressing the Return key. You can
switch the two favourite channels as you like.
Select Channels with Numeric Keys
1. Operations to select channels with 1 digit (0-9):
Press the number keys (0-9) on the remote control to
select TV channel directly.
2. Operations to select channels with 2 digits (10-99):
Press the number keys with 2 digits (10-99) on the remote
control to select TV channels.
3. Operations to select channels with 3 digits (100-399):
Press the number keys with 3 digits (100-399) on the
remote control to select TV channels.
Picture
Press the ‘’MENU’’ key, CHANNEL menu shows on the
screen. Press ‘’Left/Right’’ key to select PICTURE, then
press ‘’Up/Down’’ key to choose the item you’d like to adjust
or set.
After selecting Picture Mode, press ‘’OK’’ key to enter into
Picture Mode submenu. Press ‘’Up/Down’’ key to select item
you’d like to adjust or set.
Item Function Description
Picture
Mode
Select picture mode
„Standard”, „Soft”, „User” „Dynamic”
four modes.
Contrast
Adjust the contrast
of whole picture
Increasing analog value increases
Contrast
Decreasing analog value decreases
Contrast (0-100)
Brightness
Adjust brightness
and blackness of
whole picture
Increasing analog value increases
brightness;
Decreasing analog value decreases
brightness(0-100).
Color
Adjust the color of
whole picture
Increasing analog value increases
color temperature;
Decreasing analog value decreases
color temperature (0-100).)
Sharpness
Adjust the sharp-
ness of whole
picture
Increasing analog value increases
denition;
Decreasing analog value decreases
denition (0-100).
Tint
Adjust the tint of
whole picture
Increasing analog value increases
green;
Decreasing analog value increases
purple (0-100).
Note:
Tint can be adjusted only in NTSC system.
After selecting Color Temperature, press ‘’OK’’ key to
enter into Color Temperature submenu. Press ‘’Up/Down’’
key to select item you’d like to adjust or set.
To Next Page
Loading...
Need help?
General
