EN
INSTALLATION
① Locate the TV in a room where direct light does not strike the screen.
Total darkness or a reflection on the picture screen can cause eyestrain. Soft and
indirect lighting is recommended for comfortable viewing.
② Allow enough space between the receiver and the wall to permit ventilation.
③ Avoid excessively warm locations to prevent possible damage to the
cabinet or premature component failure.
④ This TV can be connected to 100-240V~ 50/60HZ.
⑤ Do not install the TV in a location near heat sources such as radiator, air
ducts, direct sunlight, or in a place somewhere like close compartment and
close area. Do not cover the ventilation openings when using the TV.
⑥ The indicator light will last about 30 seconds to go out after cutting off the
electricity, during this period, you cannot repower it on until the indicator
light goes out, thanks a lot for your attention!
LED1905
To Next Page
Loading...
