32L31/37L31/42L31/50L31 中性英文说明书(欧洲模数)(308B方案)T9大板 1304154
lightning, static electricity and so on,
which are possibly to disturb the
normal operation of this machine.
Exterior influence, for example
machine.
Can not operate this
Electrical release at turning off.
It is normal.
Noise Signals at turning off.
Remote control distance is
short, lose control.
1. Receive window of remote control
was covered by objects.
2. The battery energy of remote control
is to low.
1. Remove objects, obstructing the receiver window
of remote control.
2. Change battery.
Computer display is faint.
1. Adjustment is incorrect.
2. Display mode is incorrect.
1. Use auto-adjustment function.
2. Use recommended mode.
Computer display image
does not fill the screen.
1. Adjustment is incorrect.
2. Display mode is incorrect.
1. Use Auto-adjustment function.
2. Enter "PICTURE" to adjust horizontal or vertical
position.
3. Use recommended mode.
Computer no display, and
prompt no signal input, red
indicator LED twinkling.
Signal cable is loose or fallen off.
Check signal cable whether or not loose, fall off,
reconnect again.
Press " " button to turn off electrical source, then
press " " button to turn on the TV again after 1-2
minutes.
Basic Operations
TV no sound.
1.Volume setting is too low.
2.Sound is muted.
1. Adjust volume to proper value.
2. Press "MUTE" key to eliminate mute.
TV image has shadows.
1. TV signal is reflected by valley or
building.
2. Direction of antenna is incorrect.
1. Use high directional antenna.
2. Adjust direction of antenna.
No image. No sound.
Power plug is loose, power cord don't
connect well.
Symptom
Factor
Solution
Snowflake speckle and
sound noise.
TV image is better, but has
noise.
Antenna cable connector is loose,
cable is damaged.
Check the antenna cable connector plug whether
or not loose, check cable condition.
1. Check power cord whether or not connect well.
2. Check if " " button on the panel is on.
1. Antenna cable connector is loose,
cable is damaged.
2. Antenna cable type is not matching.
3. Direction or position of antenna is
incorrect.
4. Signal is weak.
1. Check the antenna cable connector plug whether
or not loose, cable whether or not perfect.
2. Check antenna cable type(VHF/UHF)
3. Adjust direction or position of antenna .
4. Attempt to use signal amplifier.
TV image has stripes.
Signal is exposed to interference, such
as car, neon light, electric blower etc.
Don't use electric blower around machine, adjust
antenna cable direction to reduce interference.
Troubleshooting
18
Set A: Press "t/u" key to select this function, press "OK" key to set A and B, the film will circulating
play in the time of A to B.
SF: Press "t/u" key to select this function, press "OK" key to slow down play speed. Press "PLAY"
key to play normally.
Step: Press "t/u" key to select this function, press "OK" key to play one step by step. Press "PLAY"
key to play normally.
To Next Page
Loading...
Need help?
General
