Manta SPK614 - Random Play; Aux-In Operation

EN – SPK614
11
REPEAT PLAY
You can play one track or all tracks on the USB repeatedly.
To Repeat a Single Track
1. Press and hold the EQ/P-MODE button on unit during play, the display will show “
” and the current track will
be played over an over again.
2. To cancel repeat play, press and hold the EQ/P-MODE button on unit until “
” disappears from the display.
To repeat all the Tracks
1. Press and hold the EQ/P-MODE button on unit until the “
” shows steadily on the display, all tracks on the
USB will be played over and over again.
2. To cancel repeat play, press and hold the EQ/P-MODE button on unit until “
” disappears from the display.
To repeat the folder (only for USB which contains more than one folder)
1. Press and hold the EQ/P-MODE button on unit until “
FOLDER” shows steadily on the display, the current
folder will be repeated over and over again.
2. To cancel repeat play, press and hold the EQ/P-MODE button on unit until “
FOLDER” disappears from the
display.
RANDOM PLAY
Press and hold the EQ/P-MODE button on unit in play mode till the “RAND” shows steadily on the display, the
random play will start from next track automatically. Press the EQ/P-MODE button on unit again until the “RAND”
disappears from the display to cancel.
BLUETOOTH OPERATION
1. Press the FUNCTION/LIGHT button on unit to switch to BLUETOOTH function, the LCD will display “bt” and the
pair indicator will flash at high speed.
2. Turn on the Bluetooth function on the device, scan the unit “SPK614” and connect, then input the password
0000 if required, the pair indicator keep light up to indicate connection done, and the display will show “bt”. Press
Play to start playback.
3. Press the
or button on the unit or adjust the volume on the external device to increase or decrease the
music volume to your desired level.
4. Press and hold the PLAY/PAUSE/BT button to disconnect Bluetooth.
Note: The Bluetooth works best within 10 meters in open air.
AUXIN OPERATION
1. Press the FUNCTION/LIGHT button on unit to select the “AUX” mode.
2. Connect your audio device to the AUX IN jack on the top panel of the unit with an AUX IN cable.(audio cable is
not included)
3. Press the
or button on the unit or adjust the volume on the external device to increase or decrease the
music volume to your desired level.
4. Control the playback with your audio device.