To Next PageTo Next PageWhy is my Mantis Tiller engine noisy or knocking?
If your Mantis Tiller engine is noisy or knocking, the spark plug might be in the incorrect heat range; replace it with plugs specified for the engine. Alternatively, the bearings, piston ring, or cylinder walls may be worn, requiring you to contact your local authorized dealer.
What causes my Mantis 7234 engine to continuously flood?
If your Mantis Tiller engine continuously floods, the fuel tank vent line may not be in an upright position (2-Cycle only). Return the fuel tank vent line to the upright position and place it under the cylinder cover in the small “pocket” in the cylinder cover.
How to fix Mantis 7234 Tiller tines not turning?
If the tines on your Mantis Tiller don’t turn when the throttle is depressed, the engine may not be seated properly on the gear housing. Re-install the engine following the instructions on page 18 (How to reseat the fl ange).
Why is my Mantis 7234 engine overheating?
If your Mantis Tiller engine is overheating, it could be due to insufficient oil in the fuel mixture. To resolve this, mix the fuel as described in the starting instructions. Another possible cause is obstructed airflow, so clean the flywheel cylinder fins and screen.
What to do if Mantis Tiller engine misses?
If your Mantis Tiller engine misses, it could be due to dirt in the fuel line or carburetor, so remove and clean them. Another cause could be an improperly adjusted carburetor (see “Carburetor Adjustment”). Additionally, the spark plug might be fouled, broken, or have an incorrect gap setting; clean or replace the spark plug and set the gap to .024-.028 in. (0.6-0.7 mm). A weak or intermittent spark at the spark plug could also be the problem, in which case you should contact your local authorized dealer.
Why does my Mantis 7234 engine stall under load?
If your Mantis Tiller engine stalls under load, it could be because the carburetor adjustment is too “lean”. Refer to “Carburetor Adjustment” for instructions. Another potential cause is the engine overheating; remove any dust and dirt from between the fins.
General
