Mantis 7265 User Manual (English)

Questions and Answers:

F
Frank SmithJul 31, 2025
Why won't my Mantis Tiller start?
- J
  John EscobarJul 31, 2025
  Several factors could prevent your Mantis Tiller from starting. First, ensure the o/i switch is in the “i” position. Check that the fuel tank isn't empty and the fuel strainer and line aren't clogged. A shorted, fouled, or broken spark plug or a disconnected ignition lead wire could also be the culprit. Replace the spark plug or reattach the lead wire as needed. If the ignition is inoperative, contact your local authorised dealer.
J
jacqueline21Aug 5, 2025
How to fix Mantis 7265 that is hard to start?
- B
  Brian KingAug 5, 2025
  If your Mantis Tiller engine is hard to start, the issue might be water in the petrol, a stale fuel mixture, or the engine being under or over choked. In this case, drain the entire system and refill it with fresh fuel or the correct mixture. Gasket leaks in the carburettor or cylinder base could also be the problem, so replace the gaskets. If there is a weak spark at the spark plug, contact your local authorised dealer.
J
Jason GouldAug 10, 2025
What to do if black smoke comes from the Mantis 7265 exhaust?
- N
  Natalie GarciaAug 10, 2025
  If you notice black smoke coming from the Mantis Tiller exhaust, it could be due to a clogged exhaust screen or a restricted exhaust port. Try cleaning the carbon from the exhaust screen and cleaning the exhaust port to resolve this issue.
T
Tina Hamilton MDAug 15, 2025
Why does my Mantis Tiller engine miss?
- A
  Anna ClaytonAug 15, 2025
  If your Mantis Tiller engine is missing, it could be due to dirt in the fuel line or carburettor. Remove and clean these parts. Alternatively, the carburettor might be improperly adjusted. Try cleaning or replacing the spark plug and set the gap to 0.024-0.028 inches (0.6-0.7 mm).
C
Craig JohnstonAug 20, 2025
What causes continuous flooding in a Mantis 7265 engine?
- M
  Mary NelsonAug 20, 2025
  Continuous flooding in a Mantis Tiller engine can be caused by the fuel tank vent line not being in an upright position. To fix this, return the fuel tank vent line to the upright position and place it under the cylinder cover in the small “pocket” in the cylinder cover.
J
Jonathon MitchellAug 26, 2025
Why aren't the tines turning on my Mantis 7265 when I press the throttle?
- K
  Karen MyersAug 26, 2025
  The tines might not turn on your Mantis Tiller when the throttle is depressed if the engine is not seated properly on the gear housing. Re-install the engine following the instructions on page 18 (How to reseat the flange).

Mantis 7265 Specifications

General

Brand	Mantis
Model	7265
Category	Tiller
Language	English

Summary

Safety Rules & Warnings

General Safety Information

Covers special safety warnings, general warnings, and safety decal information.

Operational Safety Do's and Don'ts

Provides guidance on safe operating practices and common mistakes to avoid.

Engine and Fuel Safety Do's and Don'ts

Details essential precautions for handling fuel and operating the engine safely.

Assembly

Parts and Tools

Lists all included parts and necessary tools for assembling the tiller.

Lower Handle Assembly

Step-by-step instructions for assembling the lower section of the tiller handles.

Kickstand Assembly

Instructions for attaching the kickstand for stability.

Tine Assembly

Guide for correctly attaching the tiller tines to the drive shaft.

Upper Handle Assembly and Positioning

Detailed steps for assembling and adjusting the upper handle section.

Fuelling & Starting

4-Stroke Tiller Fuelling and Oil

Instructions on how to add the correct type and amount of oil and fuel.

4-Stroke Tiller Starting

Procedures for starting the engine for the first time or when cold.

Corrective Action for Overfilled Oil

Steps to take if the engine crankcase has been overfilled with oil.

Proper Oil Fill and Level Check

Visual guide on checking and filling the engine oil correctly.

Operation

Using Your Mantis Tiller

Guidance on the proper technique for tilling and cultivating.

Tilling Depth Control

How to adjust the tiller for deeper tilling or shallow cultivation.

Switching Between Tilling and Cultivating

Procedure to reverse tines for different soil working modes.

Transportation and Storage

Tiller Transportation

Instructions on safely transporting the tiller by hand or in a vehicle.

Storage Instructions

Guidance on proper storage of the tiller to prevent damage or issues.

Maintenance

Transmission Grease Level Check

Procedure for checking and maintaining transmission grease levels.

Engine Oil Level Check

Reminder to check engine oil as part of routine maintenance.

How to Reseat the Flange

Troubleshooting steps for when tines do not turn due to a loose engine flange.

Trouble Shooting

Engine Starting Problems

Solutions for issues like failing to start, hard starting, or flooding.

Engine Running Problems

Addresses issues such as engine misses, lack of power, or overheating.

Tine Operation Issues

Guidance for troubleshooting when tines do not engage or turn properly.

Declaration of Conformity

Compliance with Directives

Lists European directives and regulations the machine complies with.

Sound and Vibration Measurements

Provides measured sound power and vibration levels for the tiller.

Limited Warranty

Tines Guaranteed

Details the lifetime warranty specifically for tiller tines against breakage.

Five-Year Component Warranty

Outlines the warranty coverage for all tiller components for five years.

Lifetime Service and Support

Information about ongoing service availability and parts acquisition.

Please Call Us First!

Contact information for customer service and initial troubleshooting.

Related product manuals

Mantis 7265 User Manual

Table of Contents

Questions and Answers:

Mantis 7265 Specifications

Summary

Safety Rules & Warnings

General Safety Information

Operational Safety Do's and Don'ts

Engine and Fuel Safety Do's and Don'ts

Assembly

Parts and Tools

Lower Handle Assembly

Kickstand Assembly

Tine Assembly

Upper Handle Assembly and Positioning

Fuelling & Starting

4-Stroke Tiller Fuelling and Oil

4-Stroke Tiller Starting

Corrective Action for Overfilled Oil

Proper Oil Fill and Level Check

Operation

Using Your Mantis Tiller

Tilling Depth Control

Switching Between Tilling and Cultivating

Transportation and Storage

Tiller Transportation

Storage Instructions

Maintenance

Transmission Grease Level Check

Engine Oil Level Check

How to Reseat the Flange

Trouble Shooting

Engine Starting Problems

Engine Running Problems

Tine Operation Issues

Declaration of Conformity

Compliance with Directives

Sound and Vibration Measurements

Limited Warranty

Tines Guaranteed

Five-Year Component Warranty

Lifetime Service and Support

Please Call Us First!

Related product manuals