Mantis 7265 - Declaration of Conformity; Compliance with Directives; Sound and Vibration Measurements

The Undersigned Manufacturer:
Schiller Grounds Care, Inc.
1028 Street Road
Southampton, PA 18966, USA
EU Authorised Representative:
Earlsmere Limited
Unit 18 Valley Road
Station Road Industrial Estate
Wombwell, Barnsley, South Yorkshire, S73 OBS UK
Notied Body:
Société Nationale de Certication et
d’Homologation (SNCH) No. 0499
11, route de Luxembourg L-5230 Sandweiler
Declare that the machine described below:
Make & Type: ................................................ Mantis Motor Hoe (Tiller)
Category: ...................................................... Motor Hoe, Hand Held, Pedestrian controlled, Petrol Powered
Series (model): .............................................. 7265
Engine: .......................................................... 
Speed: ........................................................... 7000 R.P.M
Net Installed Power: ...................................... 0.61 KW
Operation Width: ........................................... 229mm (9”)
Complies with the provisions of the following European Directives and Amendments and the Regulations transposing it into
national law:
Machinery Directive ..................................... 2006/42/EC
EMC Directive ............................................... 2004/108/EC
Noise in the Environment Directive ............... 2000/14/EC - Annex VI
Vibration Directive ......................................... 2002/44EC
Non Road Emissions ................................... 2002/88/EC
Pedestrian Controlled Motor Hoe .................. EN 709
Sound: Sound levels were determined in accordance with Directive 2000/14/EC amended by 2005/88/EC, Annex VI
Measured Sound power level: ...................... 90 dB (A)
Guaranteed Sound power level: ................... 93 dB (A)
Sound Pressure: ........................................... 77 dB (A)
Vibration:
Hand/arm vibration was measured at the right and left operator handles per ISO 5349 and EN709+A2. Vibration is
given as the vector sum of acceleration in the x, y and z axes. Only the highest of the left and right readings is given.
Vibration measurements ............................... 6.7 m/s²
Intended Use: These machines is designed for use in the garden for tilling soil up to 25cm (10”) deep or gently cultivate the
surface 5- 7.8cm (2”-3”deep)
Jim White
Managing Director
Date: 22nd, September, 2011
Pat Cappucci
President
Date: 22
nd
, September, 2011
