16
Maintain lo
g splitter with care
• Keep the blade of the log splitter sharp and clean for better and safer performance
• Follow instructions for lubrication and oil change
• Keep proper oil level
• Inspect tool cord periodically and, if damaged, have it replaced by an authorized service facility
• Inspect extension cord periodically and replace, if damaged
• Keep cart dry, clean and free from oil and grease
Area Maintenance procedure Frequency
Inspect /Tighten
Nuts, Bolts, hardware
Before each use
Visually Inspect All Welds.
Check alignment of moving parts and for
damaged or worn parts.
Before each use
Replace Hydraulic oil
when oil viscosity and force decrease.
You need 0.83 of a gallon (3.15 liters)
of oil to fill up the reservoir
(after old oil is completely drained).
(See section I for instructions)
Recommended Hydraulic oil type:
Shell Tellus T22
Aral Vitam GF22
SP Energol HCP22
Mobil DTE11 or equivalent
Do not mix fluid brands and types!
Do not use other grade oils.
After approximately
100 hours of operation
Clean/Lubricate
Machine and cart
After each use
IMPORTANT!
SKILLED AUTHORIZED PERSONNEL SHOULD PERFORM ANY MAINTENANCE
OR REPAIR OPERATION NOT DESCRIBED ABOVE.
To Next Page
Loading...
Need help?
General