8
3. Important extension cord information
• Make sure the extension cord is in good condition before use.
• Based on the total length of cord that you are going to use, check the chart to make sure the cord meets the correct
minimum cord gauge (AWG) requirements.
• Don’t overload extension cords by plugging in appliances that draw a total of watts more than the rating of the cord.
• Do not abuse the cord; never yank it to disconnect it from the socket or outlet.
• Keep cord away from heat, oil and sharp edges.
• Never expose log splitter to rain or operate in wet conditions.
• Never attempt to move or reposition the log splitter by pulling the cord.
• Don’t operate the log splitter with a damaged electrical or extension cord.
• Never operate the log splitter unless the power cord is plugged into a properly grounded outlet that supplies 110-120V
power, and a minimum of 15 amps of current.
4. Disconnect power cord from power source
• When not in use
• Before servicing
• Before clearing blockages
• Before checking, cleaning or working on the cutting portion of the unit.
• When you need to move or reposition machine.
• Whenever you leave the unit
5. Hydraulic safety
Periodically check for hydraulic fluid leaks by placing a sheet of cardboard under the wood splitter when system is running.
IMPORTANT NOTE:
USING AN UNDERSIZED CORD, A LARGER NUMBER CORD GAUGE
(AWG) THAN RECOMMENDED IN THE CHART, OR AN EXCESSIVELY
LONG CORD COULD CAUSE A LOSS IN POWER (VOLTAGE DROPS).
THIS PREVENTS THE MOTOR FROM DEVELOPING ITS FULL POWER
AND OVERHEATS THE UNIT.
Length (feet) 0 to 25 25 to 50
Cord Gauge (AWG) 14 12
EXTENSION CORD CHART
WARNING
NEVER USE YOUR HAND OR ANY PART OF YOUR BODY TO CHECK FOR HYDRAULIC
SYSTEM LEAKS WHILE SYSTEM IS PRESSURIZED.
ESCAPING PRESSURIZED FLUID CAN HAVE ENOUGH FORCE TO PENETRATE
SKIN AND CAUSE SERIOUS INJURY.
To Next Page
Loading...
Need help?
General