Marantz 10 - Page 53

Setting remote control codes for the
remote control
o
To set the remote control codes to AMP 1,
AMP 2 or AMP 3
1
Press AMP.
0
Set the remote control to amplifier operating mode.
2
Hold down i and one of the number 1, 2 or 3 buttons
for more than 5 seconds.
The remote mode select indicators will flash green.
0
Set the remote control code to AMP 1, AMP 2 or AMP 3
according to the selected number button.
Setting remote control codes for the
main unit
1
Point the remote control for which the remote control
code was set at the main unit, and press i and ENTER.
When setting the remote control code of the main unit is complete,
the remote control code set (AMP 1 – 3) is displayed on the display.
Contents Connections Playback Settings Tips Appendix
53
Front/Top
panel
Rear panel
Remote control
unit
Index