Disabling SACD player/streaming preamplifier operating mode on remote
control
SETUP
SACD
LINK
Remote mode
select indicators
If you do not want to use this unit in combination with SACD 10 or LINK
10n, you can disable the remote control operating mode of the device that
you are not using. By default, all remote control operating modes are
enabled.
0
When remote control operating mode is enabled, be sure to check the operation of
your device.
Contents Connections Playback Settings Tips Appendix
54
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
