Marantz 10 - Page 57

Setting the device to be operated by
the volume buttons in SACD player
operating mode
If you use a Marantz SACD player in combination with this unit, you can
adjust the volume of this unit without switching to amplifier operating mode
while the included remote control is set to SACD player operating mode.
By default, the device to be operated is set to “Amplifier”.
o
Set the device to be operated by the volume
buttons to this unit (amplifier)
1
Press and hold ENTER and 1 on the remote control
simultaneously for 5 seconds or more.
The AMP indicator will flash green.
o
Set the device to be operated by the volume
buttons to the streaming preamplifier
1
Press and hold ENTER and 2 on the remote control
simultaneously for 5 seconds or more.
The LINK indicator will flash green.
Setting the device to be operated by
the volume buttons in streaming
preamplifier operating mode
If you use a Marantz streaming preamplifier in combination with this unit,
you can adjust the volume of this unit without switching to amplifier
operating mode while the included remote control is set to streaming
preamplifier operating mode.
By default, the device to be operated is set to “Streaming Preamplifier”.
o
Set the device to be operated by the volume
buttons to the streaming preamplifier
1
Press and hold ENTER and 1 on the remote control
simultaneously for 5 seconds or more.
The LINK indicator will flash green.
o
Set the device to be operated by the volume
buttons to this unit (amplifier)
1
Press and hold ENTER and 2 on the remote control
simultaneously for 5 seconds or more.
The AMP indicator will flash green.
Contents Connections Playback Settings Tips Appendix
57
Front/Top
panel
Rear panel
Remote control
unit
Index