Error messages
When multiple MODEL 10 units are connected by F.C.B.S., the error messages described in the table below may be displayed on the display. In such a
case, ID setting or remote cable connection may be in failure. Check the ID or remote cable connection, referring to the table below. For details on ID
setting, see “How to set ID for F.C.B.S.” (v p. 28).
Error Code Meaning Cause / Solution
001 Multiple amplifiers take ID “Member 1”.
0
Assign different IDs to the amplifiers.
002 Multiple amplifiers take ID “Member 2”.
003 Multiple amplifiers take ID “Member 3”.
011 The amplifiers with ID “Member 1 - 3” cannot communicate with the
amplifier with ID “Leader”.
0
If the amplifier with ID “Leader” is not on, turn it ON.
0
Check that the remote cable is properly connected.
012 The amplifier with ID “Leader” cannot communicate with the
amplifiers with ID “Member 1 - 3”.
0
If multiple amplifiers take ID “Leader”, set IDs properly.
0
If the amplifier with ID “Leader” is connected to the amplifier with
ID “Off”, set IDs properly.
0
Check that the remote cable is properly connected.
Contents Connections Playback Settings Tips Appendix
67
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
