Marantz CD5005 Owner's Manual

Connecting devices with remote control connectors
When you use this unit connected to a Marantz amplifier, this unit receives operation signals sent from the amplifier and operates accordingly.
Next, configure the “Connections” and “Settings”.
Connection
Use the supplied remote connector cable to connect the REMOTE
CONTROL IN connector of this unit to REMOTE CONTROL OUT
connector of the amplifier.
Setting
Turn the EXTERNAL/INTERNAL switch on the unit to “EXTERNAL”.
0
This setting will disable remote sensor reception of this unit.
0
To operate the unit, point the remote control at the remote sensor of the
amplifier.
To use this unit by itself without connecting an amplifier, turn the switch to
“INTERNAL”.
.
This unit
Remote
connector
cable
(supplied)
Signal flow
Amplifier
Set to
“EXTERNAL”.
Contents Connections Playback Settings Tips Appendix
20
Front panel Display Rear panel Remote Index

Marantz CD5005 Specifications

General

CD changer	No
Device type	HiFi CD player
MP3 playback	Yes
Product color	Gold, Silver
Number of decks	1 deck(s)
Disc loading type	Tray
Frequency range	20 - 20000 Hz
Audio formats supported	AAC, MP3, WMA
Signal-to-Noise Ratio (SNR)	110 dB
Total Harmonic Distortion (THD)	0.002 %
Headphone outputs	1
Headphone connectivity	6.3 mm
Power consumption (standby)	0.3 W
Power consumption (typical)	14 W
Volume control	Rotary
Cables included	AC
Playback disc formats	CD audio
Remote control type	RC002PMCD

Weight and Dimensions

Depth	338 mm
Width	440 mm
Height	105 mm
Weight	5000 g