Marantz CR2020 User Manual

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of suffi-
cient magnitude to constitute a risk of electric shock
to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE
OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA
BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQU’AU FOND.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV (Cable-TV) system installer’s attention to Article 820–40 of the NEC, that
provides guidelines for proper grounding and, in particular, specified that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by tuning
the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the follow-
ing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV techni-
cian for help.
NOTE:
Changes or modifications may cause this unit to fail to
comply with Part 15 of the FCC Rules and may void the
user’s authority to operate the equipment.

Marantz CR2020 Specifications

General

Brand	Marantz
Model	CR2020
Category	Cassette Player
Language	English

Summary

Safety and Warnings

Risk of Electric Shock Hazards

Safety warnings regarding opening the unit and internal voltage.

Fire and Moisture Prevention

Precautions against exposing the appliance to rain or moisture.

Plug Insertion Safety

Instructions for proper insertion of the power plug into the outlet.

Installation and Compliance Notes

CATV System Installer Guidelines

FCC Part 15 Compliance

Information on FCC rules for digital devices and potential interference.

General Safety Instructions

Laser Safety Precautions

Hazardous Radiation Exposure Warning

Caution regarding hazardous radiation exposure from controls or procedures.

Additional Safety Precautions

Environmental and Surge Protection

Object Entry and Servicing Safety

Warnings against object/liquid entry and self-servicing.

System Connections

D-BUS Remote Control Bus

Connecting Marantz system components via D-BUS for remote control.

AL-Bus System Connection

Main Unit Connectors

Speaker, Bus, and Digital Outputs

Main Unit Controls - Power and Operation

Power and Basic Operation Buttons

Remote Control Unit - Basic Operations

Power, Source, and Numeric Input

Control Buttons and Volume Adjustment

Remote Control Unit - Advanced Modes

Playback and Tuning Mode Selection

Playing Programme Sources

Normal Playback Procedure

Steps for playing sources like CD, FM/AM, AUX, MD, and cassette tape.

Tuner and Preset Memory Operations

Tuner Listening and AM Scanning

How to listen to FM/AM radio and adjust AM scanning steps.

Preset Memory and Station Naming

Recalling Preset Stations

Remote Control Recall Methods

Tuning and Time Setting Procedures

Setting Current Time and Program Timer

Timer and Sleep Timer Functions

Sleep Timer Setting and Cancellation

CD Playback Operation Basics

Initiating CD Playback and Disc Loading

Steps to start CD playback, including disc loading and initial display.

CD Playback Navigation and Modes

Basic Playback and Disc Handling

Playing, pausing, stopping, and removing the CD disc.

Track Search and Skip Operations

Repeat and Random Playback Modes

CD Programmed Playback

Programming and Managing Tracks

Creating, playing, checking, and clearing programmed track sequences.

CD Edit Playback Features

Normal Edit Playback Setup

Setting up normal edit playback for recording CD tracks onto tape.

CD Edit Playback Modes

Full Edit for Tape Recording

Recording CD tracks onto tape with 4-second gaps and tape side allocation.

MD Edit for MD Recording

Recording CD tracks onto MD, checking available recording time.

Troubleshooting Common Issues

Audio Output and Sound Problems

Diagnosing issues with one-sided sound, hum, buzz, or howl.

Power, Indicator, and Recording Faults

Resolving problems with no power, incorrect indicators, or failed recordings.

CD Playback Troubleshooting

Addressing issues like CD not playing or playback stopping intermittently.

Model CR2020 Technical Specifications

Tuner and Amplifier Specifications

CD Player, Power, and Dimensions