9
ENGLISH
ee
ee
e
To start recording press
00
00
0
REC
(4).
➔ The display shows the real remaining time for the se-
lected recording. High speed recording starts.
lights continuously.
• To check the elapsed recording time, press
DISPLAY
(72).
This can be done during recording.
• Recording will stop automatically.
Note:
Copy prohibited tracks will be copied analog.
is displayed.
rr
rr
r
To stop recording manually, press
99
99
9
STOP
(5, 24, 82).
➔
goes out and recording stops.
• If 9
STOP
(5, 24,82) was pressed within 3 seconds after 0
REC
(4), no recording will take place.
• After recording, the display shows for several sec-
onds. The Total time indications can differ slightly. However,
no music information is lost.
Note:
- In this Recording mode, the Pause function is not operative.
Important:
If you want to play the recorded CD-R(W) disc on any regu-
lar CD player, it must first be finalized. (See FINALIZING/
UNFINALIZNG page 13).
There is a chance that the sound will be distorted if the
recording level is set at a value that exceeds 0 dB for dig-
ital sound sources and -12dB for analog sound sources.
The factory settings at the time of shipping are 0 dB for
digital sound sources and -12dB for analog sound
sources.
Finalized CD-RW discs play only on CD-RW compatible CD
players.
RECORDING (FROM INTERNAL CD-DECK)
The numbers between parentheses refer to the fold-out.
MENU/
STORE
CANCEL/
DELETE
0
987
654
321
RANDOMPROG.REPEATSCAN
CD
CDR
ABC DEF GHI
JKL MN OPQ
RST UVW XYZ
DISPLAY
SPACE
SCROLL
FUNCTION
ENTER
Recordable
ReWritable
SOURCEREC TYPE
CLOSE
OPEN/
CLOSE
OPEN/
ERASE FINALIZE
POWER
ON/OFF
PLAY/PAUSESTOP
REC
CDR
CD RECORDER DR6050
PLAY/PAUSESTOP
CD DJ MODE
EASY JOG
PUSH ENTER
CANCEL/DELETESTORE/MENU
PHONES
STANDBY
w
er
w
w
w
r
w
Double speed recording
Using internal CD player.
• During double speed recording the sound is not audible.
qq
qq
q
Make sure that the recording disc is absolutely free of
scratches and dust particles.
ww
ww
w
To choose the type of recording, press
REC TYPE
(11).
once: to select
if you wish to make a
fast recording of a disc or programmed tracks.
three times: to select if you wish to make a
fast recording of a disc or programmed tracks
and to automatically finalize the recording.
Also see ‘FINALIZING CD-R & CD-RW’ discs
on page 17.
The
label starts blinking. After 3 seconds
the display shows the remaining CD-R(W) recording
time on the left and total time of source on the right.
(every 2 seconds
is displayed.)
Both selection indicators are lit.
• Press
PROG
(86) on the remote control to select one or
more tracks for recording (see PROGRAMMING):
- rotate the
EASY JOG
(19) key to the required track
number, then press
PUSH
ENTER
(19).
or:
- directly select the track number via the
10-keypad
(71)
on the remote control, then press
ENTER
(79).
To Next Page
Loading...
