Marantz DVD Player User Manual

1
ENGLISH
FOREWORD
This section must be read carefully before any connection is
made to the mains supply.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not insert anything into the equipment through the
ventilation holes.
Do not handle the mains lead with wet hands.
Make a space of about 0.1 meter around the unit.
CE marking
This product is in conformity with the EMC
directive and low-voltage directive.
EQUIPMENT MAINS WORKING SETTING
Your Marantz product complies with the household power and
safety requirements in your area.
IMPORTANT: (FOR UK version only)
This apparatus is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A.
If a plug without a fuse is used, the fuse at the distribution board
should not be greater than 5A.
NOTE : The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13A socket
elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accordance with the
following code:
BLUE—”NEUTRAL” (“N”)
BROWN—”LIVE” (“L”)
1. The BLUE wire must be connected to the terminal which is
marked with the letter “N” or coloured BLACK.
2. The BROWN wire must be connected to the terminal which is
marked with the letter “L” or coloured RED.
3. Do not connect either wires to the earth terminal in the plug
which is marked by the letter “E” or by the safety earth symbol
or coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead — not simply over the two
wires.
PRECAUTIONS
The following precautions should be taken when operating the
equipment.
GENERAL PRECAUTIONS
When installing the equipment ensure that:
– the ventilation holes are not covered.
– air is allowed to circulate freely around the equipment.
– it is placed on a vibration-free surface.
– it will not be exposed to excessive heat, cold, moisture or dust.
– it will not be exposed to direct sunlight.
– it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.
If a foreign object or water does enter the equipment, contact
your nearest dealer or service center.
Do not pull out the plug by pulling on the mains lead; grasp the
plug.
It is advisable when leaving the house, or during a thunderstorm,
to disconnect the equipment from the mains supply.

Marantz DVD Player Specifications

Power

power requirements	AC 230 V, 50 Hz
power consumption	17 W

Operating Environment

operating temperature	+5°C to +35°C (+36°F to +96°F)
operating humidity	5% to 85% (no condensation)

Audio Output

output level (audio)	200 mVrms (1 kHz, –20 dB)
number of channels (audio)	2
jacks (audio)	RCA jacks

S-Video Output

y (luminance) output level	1 Vp-p (75 Ω)
c (color) output level	286 mVp-p (75 Ω)
jacks (s-video)	S-VIDEO jack

Video Output

output level (video)	1 Vp-p (75 Ω)
jacks (video)	RCA jack

RGB Output in SCART Jack

output level (RGB)	0.7 Vp-p (75 Ω)
jacks (RGB)	SCART jacks

5.1 CH Surround Audio Output

output level (5.1 ch)	200 mVrms (1 kHz, –20 dB)
number of channels (5.1 ch)	6
jacks (5.1 ch)	RCA jacks

Digital Audio Characteristics

frequency response	4 Hz to 44 kHz (DVD fs: 96 kHz)
s/n ratio	More than 100 dB
dynamic range	More than 100 dB
total harmonic distortion	0.0025 %

Weight and Dimensions

weight	4.2 kg
width	420 mm
depth	309 mm
height	76 mm