0
When “TV Input” is set in the menu, this unit automatically turns on when the TV
connected to the unit is turned on, and the input source switches to “Optical In 1”
or “Optical In 2”. (v p. 98)
NOTE
0
Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise
and could damage the speakers.
o
Specifications of supported audio formats
See “DIGITAL IN” (v p. 142).
Playing analog input
1
Prepare for playback.
Check the connection, then turn on this units.
2
Press ANALOG IN to switch the input source to
“Analog In”.
3
Play the component connected to this unit.
Contents Connections Playback Settings Tips Appendix
72
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
