Using this unit as a power amplifier
When connecting a pre-amplifier and using this unit as a power amplifier,
switch the input source of this unit to “PWR AMP”.
1
Turn the INPUT selector on the main unit to switch the
input source to “PWR AMP”.
“PWR AMP” is displayed on the display.
0
When the input source is “PWR AMP”, adjustment of the volume, balance and
tone has no effect. Adjust these adjustments on the pre-amplifier.
0
When the remote control code setting is set to “AMP1” (Default), INPUT ml on
the remote control cannot be used to switch the input source to “PWR AMP” or
switch from “PWR AMP” to another input source. To make remote control
operations, change the remote control code setting to “AMP2” or “AMP3”.
(v p. 33)
NOTE
0
When the input source is “PWR AMP”, the main unit outputs at maximum volume.
Check the output level on the input device before playing it and adjust the volume
accordingly.
Recording
Audio signals input into this unit can be output to an external recording
device. When recording audio from a playback device connected to this
unit, audio can be recorded with the playback device still connected to this
unit.
1
Press AMP X to turn the power on.
2
Use INPUT ml to switch to the input source from
which you want to record.
The selected input source appears on the display.
3
Recording starts.
0
For information on operations, see the owner’s manual of the
recording device.
Contents Connections Playback Settings Tips Appendix
29
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
