Marantz NR1506 - Page 190

Symptom Cause / Solution Page
Dolby PLg mode or DTS
Neo:6 mode cannot be
selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”.
160
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
－
Audyssey MultEQ
®
,
Audyssey Dynamic EQ
®
and Audyssey Dynamic
Volume
®
cannot be
selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
148
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
98
0
These cannot be selected when using the headphones.
－
“M-DAX” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
130
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
98
Contents Connections Playback Settings Tips Appendix
190
Front panel Display Rear panel Remote Index