z1
This item can be selected when a Dolby TrueHD signal is played.
z2
This item can be selected when a Dolby TrueHD, Dolby Digital or DTS signal is played.
z3
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z5 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 164)
z6 This item cannot be set when “Dynamic EQ” is set to “On”. (v p. 133)
z7
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z8
This item cannot be set when “MultEQ
®
” is set to “Off”. (v p. 132)
z9
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
212
Front panel Display Rear panel Remote Index
To Next Page
Loading...
