Need help?Do you have a question about the Marantz PM-94 and is the answer not in the manual?
Details the P.W. boards for the Tone (L) and Tone (R) assemblies.
Covers P.W. boards for Flat Amp/Supply and CD Direct/Balance circuitry.
Details P.W. boards for Power Transistor, Comparator, Protect, and Supply functions.
Covers P.W. boards for Main Volume, Speaker Muting, Phono/Speaker Selector, and Muting circuits.
Procedure to adjust output offset voltage for L and R channels to ±10 mV.
Steps to set idling voltage between J607 and J707 to 36 mV and 180 mV.
Adjusts amplifier bias and waveforms for optimal performance by setting pulse width and emitter voltage.
Details the P.W. boards for the Tone (L) and Tone (R) assemblies.
Covers P.W. boards for Flat Amp/Supply and CD Direct/Balance circuitry.
Details P.W. boards for Power Transistor, Comparator, Protect, and Supply functions.
Covers P.W. boards for Main Volume, Speaker Muting, Phono/Speaker Selector, and Muting circuits.
Procedure to adjust output offset voltage for L and R channels to ±10 mV.
Steps to set idling voltage between J607 and J707 to 36 mV and 180 mV.
Adjusts amplifier bias and waveforms for optimal performance by setting pulse width and emitter voltage.
General| Input Sensitivity | 0.2 mV (MC), 2.5 mV (MM), 150 mV (line) |
|---|---|
| Type | Integrated Amplifier |
| Frequency Response | 5 Hz - 100 kHz |
| Damping Factor | 100 |
| Signal to Noise Ratio | 110dB (line input) |
| Output | Speakers A, B |
To Next Page
