- 45 -
1. Select the ID1 menu choice:
Menu Default
The Default menu choice resets all Menu items to
their defaults. This is convenient if you are setting
up a new configuration because you don't have to
check all the settings, you know they are at the
default.
Defaults are listed for each menu item.
Note:
US defaults are used for illustration. See page 59 for a table
of menu defaults.
Quick instructions
Press & hold
MENU/STORE 2 sec ....... Preset
Double Click ENTER
.................. RecFormat
Press F.FWD/+ until .......................... Default
Press ENTER
.................................. Execute
Press ENTER
.......................... EXECUTING
............................................................... exits
the -/F.REV
button
to
tab through the
ID choices.
When correct press and release the ENTER
button
to
accept the ID#
choice and
switch to the highest number position.
4. Press and release the F.FWD/+ button
or
the -/F.REV
button
to tab
through the digits
0 through 9.
5. When correct, press and release the ENTER
button
to
switch to the
next digit.
6. Press and release the F.FWD/+ button
or
the -/F.REV
button
to
tab through the
digits 0 through
9.
Repeat steps 5 and 6 until all six digits are
set.
7. Press and release the ENTER button
to
switch to ID#
flashing.
8. Press and release the F.FWD/+ button
to
switch to the next ID#.
9. Repeat 5 - 8 for all three ID numbers.
10. When the upper display is flashing, press
and release the F.FWD/+ button
to
switch to another menu choice, or press and
release the
MENU/STORE button to write
the menu change(s) and return to stop mode.
1. From stop, press and hold the
MENU/
STORE button for
about 2 seconds.
Preset is flashing.
click the ENTER
button
. Menu
item is flashing.
2. With Preset flashing in the display, double
a. From stop, press
and hold the
MENU button
for about 2 seconds. Preset will appear (flash-
ing) in the display.
b. While Preset is flashing, double click the
ENTER button
.
The last Menu
choice selected
will appear.
2. Press and release the F.FWD/+ button
repeatedly until an
ID choice is
displayed and
flashing.
3. Press and release the F.FWD/+ button
or
To Next Page
Loading...
