Marantz RC3001 - Rx3001

6
ENGLISH
z DC jack
This jack connects to the supplied AC adapter.
x Antenna
This is a rod antenna for receiving RF signals.
c IR blasters (upper direction)
These transmit IR signals. The Wizz.it 3 editor
software can be used to turn transmission of the
IR signals on and off.
v IR blasters (front direction)
These transmit IR signals. The Wizz.it 3 editor
software can be used to turn the IR signal
transmissions on and off.
b IR output jack
This jack connects the supplied IR emitter cable.
n Key holes
These holes are used to mount the remote
controller to a wall. For the mounting procedure,
see “Mounting the RX3001 to a Wall” on page 8.
RX3001
m IR output level switches
These DIP switches set the IR transmission level
from IR output jacks 1 to 3 and IR output jacks
4 to 6.
, Group ID selector switch
This switch sets the IR output group ID for IR
output jacks 1 to 3 and IR output jacks 4 to 6.
. CH selector switch
This switch sets the reception channel. Set to the
same channel as the RC3001.
Note:
The CH selector has eight setting positions, but
only four channel positions can be set.
⁄0 Power indicator
The red LED turns on when the AC adapter is
connected. The red LED fl ashes when receiving
signals.
12
ID
4
3
2
1
ON OFF
RX3001
v
c⁄0
z
,
.
m
x
b
654321
n
RC3001E01ENG.indd6RC3001E01ENG.indd6 07.8.311:04:39PM07.8.311:04:39PM