Why is there no sound output from the speakers on my Marantz Receiver?
If your speakers aren't producing sound, check whether headphones are plugged into the headphone jack. If they are, disconnect them, as the speakers will be disabled when headphones are connected.
Why does control with the remote control unit fail on my Marantz SR4200 Receiver?
If the remote control isn't working with your Marantz SR4200 Receiver, try replacing the batteries with new ones. Make sure the remote controller's function-key setting is correct. Also, ensure you are close enough to the receiver and that there are no obstructions between the remote and the receiver.
What to do if my Marantz Receiver is not turning on?
If your SR4200 isn't turning on, make sure the power plug is securely connected to the outlet.
Why is there no sound output from the center speaker of my Marantz SR4200 Receiver?
If there's no sound from your center speaker, first ensure the speaker cable is properly connected. Check that the Surround mode isn't set to STEREO, as this mode deactivates the center speaker. If it is, switch to another Surround mode. Also, verify that 'Center = NONE' hasn't been selected in the SETUP mode; if it has, correct the setting.
Why is there no sound output from the surround speakers on my Marantz Receiver?
If you're not getting any sound from the surround speakers, check that the speaker cables are correctly connected. If the Surround mode is set to STEREO, no sound will be output from the surround speakers, so select a different Surround mode. Also, ensure that 'Surround = NONE' is not selected in the SETUP mode; correct the setting if needed.
What to do if my Marantz Receiver has no sound and picture even when power is on?
If your Marantz Receiver has no sound and picture despite being powered on, first ensure that mute is off by using the remote control. Then, verify that the input cables are correctly connected according to the connection diagram. Also, check the master volume to ensure it is adequately adjusted and the function selector is in the correct position.
How to fix FM or AM reception failures on my Marantz SR4200 Receiver?
To fix FM or AM reception failures, correctly connect the indoor FM and AM antennas to the appropriate FM and AM antenna outlets on your Marantz Receiver.
How to resolve noise during AM reception on my Marantz SR4200 Receiver?
If you're experiencing noise during AM reception, it could be due to interference from other electrical fields. Try changing the location of the AM indoor antenna to minimize this interference.
How do I stop my Marantz SR4200 from outputting sound from the wrong channel?
If the sound is coming from the wrong channel, the speaker cable might be connected incorrectly. Refer to the connection diagram to ensure the cable is properly connected.
How do I stop my Marantz Receiver from playing sound and pictures from the wrong equipment?
If your Marantz Receiver is playing sound and showing pictures from equipment other than what's selected, the input cable may be connected incorrectly. Refer to the connection diagram to connect the cable correctly.
General| Channels | 6.1 |
|---|---|
| Dolby Decoding | Dolby Digital, Dolby Pro Logic II |
| Video Outputs | 1 composite, 1 S-video |
| Total Harmonic Distortion | 0.08% |
| Signal to Noise Ratio | 98 dB |
| DTS Decoding | DTS, DTS Neo:6 |
| Inputs | 2 digital optical, 2 digital coaxial |
| Outputs | 1 digital audio (optical) |
| Dimensions | 440 x 158 x 416 mm (W x H x D) |
| Tuning Range | FM |
| Frequency Response | 10Hz-100kHz (+1/-3 dB) |
| Input Sensitivity | 200mV |
| Video Inputs | 4 composite, 2 S-video |
| Weight | 21.6 lbs (9.8 kg) |
To Next Page
