Marantz SR8015 User Manual

Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
.
X
ui ENTER
BACK
Disabling the sensor function of the
remote control unit
1
Press X while you press and hold BACK and ENTER
with the unit in standby mode.
2
Use ui to select “RC LOCK On”.
3
Press ENTER to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
Press X while you press and hold BACK and ENTER
with the unit in standby mode.
2
Use ui to select “RC LOCK zOff”.
(z The currently set mode.)
3
Press ENTER to enter the setting.
Infrared light receiving function on the main unit is enabled.
Contents Connections Playback Settings Tips Appendix
169
Front panel Display Rear panel Remote Index

Marantz SR8015 Specifications

General

Channels	11.2
Power Output	140 W (8 ohm, 20 Hz - 20 kHz, 0.05% 2ch Drive)
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	175 W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	250 W
70% Guarantee	Yes
Total Harmonic Distortion	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
HDMI Inputs	8
HDMI Outputs	3
HDMI Version	2.1
8K/60Hz Pass-Through	Yes
4K/120Hz Pass-Through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Auto Low Latency Mode (ALLM)	Yes
Variable Refresh Rate (VRR)	Yes
Quick Frame Transport (QFT)	Yes
Dolby Atmos	Yes
Dolby Atmos Height Virtualization	Yes
DTS:X	Yes
DTS Virtual:X	Yes
IMAX Enhanced	Yes
Auro-3D	Yes
HEOS Multi-room	Yes
HEOS Built-in	Yes
AirPlay 2	Yes
Wi-Fi	Yes
Bluetooth	Yes
Ethernet	Yes
USB Port	Yes
Phono Input	Yes