Marantz SR8015 User Manual

Front Speaker
Set the front speaker A/B to use for every sound mode.
A
(Default):
Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
0
This can be set when “Assign Mode” is set to “9.1ch + Front B”. (v p. 233)
0
This can be set by pressing SPKR A/B on the main unit.
2ch Playback
Select the method for setting the speakers used in the 2-channel direct
and stereo playback modes.
o
Setting
Select the method for setting the speakers used in the 2-channel direct
and stereo playback modes.
Auto
(Default):
The settings in “Speakers” are applied.
(v p. 221)
Manual:
Set the speakers for 2-channel playback.
Make the following settings:
o
Front
Set the size of the front speakers for 2-channel playback.
Large
(Default):
Use a large speaker that can adequately
play back very low bass frequencies.
Small:
Use a small speaker that has inadequate
playback capacity for very low bass
frequencies.
0
When “Speaker Config.” - “Subwoofer” in the menu is set to “None”, “Large” is
automatically set. (v p. 241)
Contents Connections Playback Settings Tips Appendix
251
Front panel Display Rear panel Remote Index

Marantz SR8015 Specifications

General

Channels	11.2
Power Output	140 W (8 ohm, 20 Hz - 20 kHz, 0.05% 2ch Drive)
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	175 W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	250 W
70% Guarantee	Yes
Total Harmonic Distortion	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
HDMI Inputs	8
HDMI Outputs	3
HDMI Version	2.1
8K/60Hz Pass-Through	Yes
4K/120Hz Pass-Through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Auto Low Latency Mode (ALLM)	Yes
Variable Refresh Rate (VRR)	Yes
Quick Frame Transport (QFT)	Yes
Dolby Atmos	Yes
Dolby Atmos Height Virtualization	Yes
DTS:X	Yes
DTS Virtual:X	Yes
IMAX Enhanced	Yes
Auro-3D	Yes
HEOS Multi-room	Yes
HEOS Built-in	Yes
AirPlay 2	Yes
Wi-Fi	Yes
Bluetooth	Yes
Ethernet	Yes
USB Port	Yes
Phono Input	Yes