Marantz SR8015 User Manual

General
Make various other settings.
Language
Set the language for display the menu on the TV screen.
English / Deutsch / Français / Italiano / Español / Nederlands /
Svenska / Pусский / Polski (Default : English)
0
“Language” can also be set up by the following operation. However, the menu
screen is not displayed. Watch the display while configuring the settings.
1. Press and hold the main unit’s STATUS and ZONE SELECT at the same time
for at least 3 seconds.
“zVideo Format <PAL>” appears on the display.
2.
Press i on the main unit twice.
“zGUI Language <ENGLISH>” appears on the display.
3.
Use the main unit’s o or p and set the language.
4. Press the main unit’s ENTER to complete the setting.
ECO
Configure the ECO Mode and auto standby mode settings.
o
ECO Mode
This mode can reduce the power consumption and heat generation of
this unit when power on.
This is done by reducing the power supply line to the power amplifier,
in turn the maximum power output.
Contents Connections Playback Settings Tips Appendix
263
Front panel Display Rear panel Remote Index

Marantz SR8015 Specifications

General

Channels	11.2
Power Output	140 W (8 ohm, 20 Hz - 20 kHz, 0.05% 2ch Drive)
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	175 W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	250 W
70% Guarantee	Yes
Total Harmonic Distortion	0.05%
Frequency Response	10 Hz - 100 kHz
Input Sensitivity	200 mV
Signal-to-Noise Ratio	102 dB
HDMI Inputs	8
HDMI Outputs	3
HDMI Version	2.1
8K/60Hz Pass-Through	Yes
4K/120Hz Pass-Through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Auto Low Latency Mode (ALLM)	Yes
Variable Refresh Rate (VRR)	Yes
Quick Frame Transport (QFT)	Yes
Dolby Atmos	Yes
Dolby Atmos Height Virtualization	Yes
DTS:X	Yes
DTS Virtual:X	Yes
IMAX Enhanced	Yes
Auro-3D	Yes
HEOS Multi-room	Yes
HEOS Built-in	Yes
AirPlay 2	Yes
Wi-Fi	Yes
Bluetooth	Yes
Ethernet	Yes
USB Port	Yes
Phono Input	Yes