Need help?Do you have a question about the Marantz TT-42 and is the answer not in the manual?
General| Motor | DC Servo Motor |
|---|---|
| Signal to Noise Ratio | 60 dB |
| Output Voltage | 2.5 mV |
| Platter | Aluminum Die-cast |
| Output | RCA |
| Weight | 2.8 kg |
| Speeds | 33-1/3, 45 rpm |
| Tonearm | Static balance straight type |
| Cartridge | Magnetic type |
| Recommended Load Impedance | 47 kOhms |
| Dimensions | 360 x 97 x 357 mm |
Connect the power supply unit to the turntable and mains socket for operation.
Connect audio cables to amplifier inputs and ground wire to the amplifier's ground terminal.
Select speed, remove stylus guard, and set switch to Start for automatic playback.
Select speed, lift cue lever, position tonearm, and lower gently using the cue lever.
Tonearm returns automatically and unit switches off at the end of the record.
Information on stylus wear, maintenance, and replacement for the DN 251 S stylus.
To Next Page
