Marbella VR4 - Date;Time Setup Procedure

30
© 2016 Ma k a T e c hnologie s G roup . A ll Righ ts Re s er v ed .
Getting Started
Operation of your VR4 F HD Digital Roadcorder
TM
SYSTEM SETTNG
Date/ Time Setup
Access the following settings to change the device’s time and date.
If the battery remains fully discharged or removed from the device, the
time and date is reset.
1 Press on MENU twice to enter system setting
2 Press on UP or DOWN button to navigate to the function that
shows the Date/Time
3 Press on OK to enter and in : YYYY/MM/DD HRS:MM:SS
4 Press on the UP or DOWN button to change the date and time
accordingly.
5 Press on OK button to shift your entry to the next segment
6 Press on MENU once entry complete made to exit selection
7 Press on MENU once to exit setting
Auto Power Off
This function enable you to select the auto shut down of the device if the unit is
not in the recording mode which help to alert driver.
1 Press on MENU twice to enter System Setting
2 Press on UP or DOWN button to navigate to the function that shows
Auto Power Off
3 Press on OK to enter and show : OFF/ 1min/ 3min
4 Press on the UP or DOWN button to make your selection
5 Press on OK to confirm your entry and exit selection
6 Press on MENU once exit Setting