Marco B36CF - Lineal Gain Chart; Minimum Chimney Height; Chimney Maintenance

Marco's Dclcbl~ Wd Chhep System, .rvhez
xed on the Suilder 36 5-eplac. is listed for
installaticn to a rnzuimm of 60 feet Ugh. This
measurement includes he Fneplace, chimney sez-
tiom the effective height of the termination
assembly. The &urn height of fhe fueplacz
sy sten must not 5f: less than 15 feet hcludhg the
Fmeplace, chimney sections, and termination m-
sembly. Theminhum height with two (2) elbows
(1 szt) is 15 feet, T?le mivfrllum heipht with four
(C) elbows I2 sets] is 24 feet.
mm'II.3 C- RF,TGHT:
The recomrnendcd minimum height of the chim-
ney syst-m (15 ft.) is based on the wind md
pressure conditions usuzlly found around the av-
erage Homesite, conditrions such as adja-
centhills, tall nees, high wind ares, etc. cm cause
downdrafts to occur in my chimney system ad
would therefore requixe an extra length of pipe to
emure &e proper draft conditions during the use
of the fiepl ace. Consult your supplier or the locaI
btdding inspector for qy information they may
hzve regrd:ng local wesfher chzecteri_stics,
CWY rnrnhNCE:
Rcglar inspzcdan and cleaning af he chimney
ystm is kportant, Bef~r to t5e f ardy md
Operations Mml for Insmcticms.