What to do if Marco Boiler is not filling?
If your Marco Boiler isn't filling, first check the water pressure. If the pressure is adequate, try turning the machine off and then on again. If the issue persists, it's recommended to contact a service agent for further assistance.
Details electrical and plumbing installation procedures for the boiler.
Explains the steps to operate the boiler, including indicator lights.
Provides a guide to diagnose problems using the Ready/Status light flashes.
Important safety precautions and handling advice for the appliance.
Provides technical specifications and dimensions for T20-3, T20-6, and T30 models.
Explains error codes indicated by the machine's flashing lights.
To Next Page
General
