Need help?Do you have a question about the Marco MT Series and is the answer not in the manual?
Instructions for installing the Marco MT boiler unit, covering electrical and plumbing connections.
Procedure for installing a water filter into the Marco MT boiler unit, including orientation guidance.
Steps for initial operation after installation, including water filling and heating sequence.
Guide to the basic operation of the Marco MT single-tap boiler, including screen display and tap function.
Guide to operating the Marco MT dual-tap boiler, detailing screen, buttons, and tap functions.
Instructions on how to adjust the water temperature setting on the MT boiler through the control interface.
Procedure for setting the filter usage estimate on the MT boiler to trigger filter change notifications.
Steps to switch the temperature display unit between Celsius (°C) and Fahrenheit (°F) on the boiler.
Configuration of the boiler's water filling method, choosing between Heat Fill and Continuous Fill modes.
Guide for selecting the correct voltage mode (230V or 120V) for optimal performance of the boiler.
Step-by-step instructions for safely removing the top lid of the MT boiler for internal access.
Procedure for removing the lower front panel of the MT boiler to access internal components.
Instructions for safely draining the water from the MT boiler tank before maintenance or servicing.
Guide for replacing the Printed Circuit Board (PCB) in the MT boiler, including wire disconnection.
Procedure for removing the dispensing tap from the MT boiler, cautioning to drain the tank first.
Steps for removing and replacing the heating element in the MT boiler, detailing access and disconnection.
Procedure for cleaning or replacing the high and low level probes within the MT boiler tank.
Instructions for replacing the Triac component, emphasizing correct wiring connections and noting screw locations.
Steps for replacing the inlet solenoid valve, advising to note the orientation of the mounting bracket.
Procedure for descaling the MT boiler tank to remove limescale buildup using a descaling solution.
Detailed wiring diagram for MT boilers, showing component connections and cable routing for troubleshooting.
Exploded view and parts list for MT4, MT8, and MT8F boiler models, identifying components by number.
Exploded view and parts list for the MT8DT boiler model, identifying components by number and description.
Exploded view and parts list for the MT25 boiler model, identifying components by number and description.
Exploded view and parts list for the MT30 boiler model, identifying components by number and description.
To Next Page
General
