1000762#, 763#, 764#, 765#, 766#, 1762#, 1763# Service Manual for REVIEW
Page 5 of 33
4. INSTALLATION
4.1 MT Boiler Installation
Electrical Installation:
When installing the machine, always observe the local regulations and standards. The appliance is
supplied with a moulded power cord. A suitable mains power supply socket should be available
within easy access of the appliance so that it can be disconnected easily after install.
Plumbing Installation:
• Mains water pressure required (limits): 14.5 – 145psi (100 – 1000kPa) 1.0 – 10.0 bar except
machines with built-in water filter: 14.5 – 87psi (100-600kPa) 1.0 – 6.0 bar.
• Fit a stop Valve on a cold-water line and attach a 3/4" BSP male fitting, (e.g., 3/4" x 1/2" 311
or washing machine type stop valve).
• For US versions use 9/16”-24 UNEF – male fitting.
• Connect straight tailpiece of the hose to the stop valve fitting. Make sure that the pre-
attached sealing washer is fitted.
• Turn on the water to flush any impurities, dust etc. from the inlet hose and water pipe. Allow
several litres through.
• Connect the hose to the inlet valve of the boiler (3/4" BSP). Make sure the sealing washer is
fitted.
• Turn on water and check for leaks.
To Next Page
Loading...
