CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the gym.
2. The gym can be cleaned using a damp cloth and mild non-abrasive
detergent. DO NOT use solvents.
3. Examine the gym regularly for signs of damage or wear. Pay
particular attention to the bushings on movable parts.
4. Examine the cables regularly for signs of wear and damage. Adjust
cable tension as required. This can be achieved by moving the
pulley up one hole on the Floating Pulley Bracket or moving the C
Clip up one link on Chain #77.
5. Failure to examine the gym regularly may affect the safety
level of the equipment.
6. Periodically, spray the Guide Rods # 9 with silicon spray or light oil
to ensure a smooth operation.
7. Replace any defective components immediately and/or keep the
gym out of use until repair.
8. Ensure all Pull Pins are properly located before using the gym.
9. Ensure Lat Bar #22 is properly stored when not in use.
Dimensions: H: 208cm x W: 182cm x L: 213cm
28
To Previous Page
