3.6 UPGRADE
When a new version of the software is detected, it can be upgraded.
3.7 REMOVE
To unlink the phone and smart watch.
Note: For iPhone users, go to “Settings” - “Bluetooth”, to ignore current Bluetooth pairing in
order to unlink completely.
3. Main functions
3.1 Basics
3.1.1 Power ON: When watch is power off, long press the side button for 5 seconds to power
on. In the standby state, short press the side button to wake up it.
3.1.2 Power OFF: When watch is power on, long press the side button for 5 seconds to
power off directly.
3.1.3 Check Device information: Long press the touch key to enter the Message interface.
You can see the Bluetooth name, device type, device address, etc.
3.2 Steps
You can view pedometer data on watch and APP. When watch is successfully paired with APP,
your sport data will automatically synchronize (or manually refresh) from watch to the APP,
including steps count, distance, calories and other parameters.
3.3 Sleep monitor
The default sleep monitor time for the watch is from 20:00 pm to 10:00am. If you wear the watch
when sleeping, you can check last night’s sleep time on the watch after getting up the next
morning. When watch is successfully paired with APP, the sleep data will be automatically
synchronized (or manually synchronized) to the APP. The watch will automatically recognize and
judge which is the sleep state. If you just get up briefly from bed, the sleep data displayed on the
watch is different from the actual data because the watch is still detecting sleep. It is only when
the watch completes detection that will show results of the whole night, and is consistent with
the actual data. It will be acceptable to have some errors with the actual data due to different
sleep states.
3.4 Heart rate monitor
To Next Page
Loading...
