35
Surfacing - Air
When the measured depth is less than 1 m (3 ft) the dive
is suspended ("Surfacing") and the dive timer is halted. If
the diver does not return below 1.2 m (4 ft) within the
next 3 minutes, Nemo considers the dive finished and
records its data in the Log Book. If the diver does re-
descend within 3 minutes, the dive continues and the
dive timer resumes from where it left off.
Data displayed in Surface mode:
• duration of the dive;
• maximum depth;
• any icons for underwater behavior errors (omitted
stop, uncontrolled ascent).
Surface Mode - Air
When the dive is considered finished, Nemo switches
from Dive Mode to Time Mode, with the desaturation
and no-fly times shown on the display bar as described
in the Time Mode section.
In addition, Nemo displays the icons for any underwater
behavior errors (omitted stop, uncontrolled ascent) that
occurred during the dive. For further information, refer
to the "Time" section of this manual.
WARNING
Do not fly or travel to high altitudes
while the no-fly indication remains
active.
EN
To Next Page
Loading...
