EN
Predive - Nitrox (EAN)
This operating mode remains active until the diver goes
below 1.2 meters (4 feet).
The following data is displayed:
• type of dive (EAN);
• units of measurement (m-°C or ft-°F);
• type of water (Salt, Fresh);
• altitude program (if enabled) and level;
• personal correction factor (if enabled) and level;
• battery power level.
The battery power level is indicated graphically along
the perimeter of the display.
If the indication drops below the "6 o'clock" position it
is advisable to replace the battery immediately before
diving in particularly cold water, or if a lengthy series of
dives is planned. Do not dive if the battery power level
is less than 25% (graphically equivalent to one quarter
of the dial). If the battery power indicator drops below
the "2 o'clock" position, the "low battery" icon will
appear. In this case, the backlight function will be
disabled. Under these conditions, the battery has a
residual life of two more standard dives and should
therefore be replaced immediately.
When the power indicator drops below the "1 o'clock"
mark Nemo disables the dive computer, and only the
time function remains active. Immediately replace the
battery to resume using it as a dive computer.
Note:
Before every dive, it is advisable to
enter Set Dive mode and check all the
parameter settings, and especially the
Nitrox parameters.
Note:
If Predive Mode persists for more
than 10 minutes without any button
being pressed, Nemo will revert to
Time Mode.
38
WARNING
It is recommended to always to
begin the dive with Nemo set to
Predive mode.
This ensures correct functioning even
if the wet contacts are dirty with salt,
oil, sunscreen etc...
In any case, as you begin your dive
always check that the computer has
effectively activated.
To Next Page
Loading...
