It is advisable to periodically clean the surface of the sensor which detects contact with
water, to prevent any deposits from compromising the correct functioning of Nemo. Do
not use chemical products; wiping with a soft cloth is sufficient.
At the end of a dive (even in a swimming pool) or whenever Nemo has been submerged,
wipe the surface of the sensor which detects contact with water.
After diving in seawater it is recommended to rinse Nemo with fresh water, to remove any
residues of salt.
Note:
if signs of moisture are observed on the interior of the mineral glass, take your Nemo immediately to an
authorized Mares service center. In any case, Mares declines responsibility for any water infiltrations resulting
from an incorrect battery replacement procedure.
WARNING
The steel case and the mineral glass are not exempt from possible scratches caused by improper use.
Maintenance
60
EN
To Next Page
Loading...
