Mares Puck Pro - Page 2

Puck Pro Dive Computer
2
• TABLE OF CONTENTS
1 INTRODUCTION 3
1.1 GLOSSARY 3
1.2 OPERATING MODES 4
1.3 USERREPLACEABLE BATTERY 4
1.4 CONNECTING PUCK PRO TO A PC OR MAC 4
1.5 BUTTON OPERATION 4
2 MENUS, SETTINGS AND FUNCTIONS 6
2.1 MODE 6
2.2 SET 6
2.2.1 SET DIVE 7
2.2.1.1 LGHT BACKLIGHT 7
2.2.1.2 P P FCT P FACTOR 7
2.2.1.3 ALT ALTITUDE 7
2.2.1.4 WATR WATER 7
2.2.1.5 UN:TS UNITS 7
2.2.1.6 FAST FAST ASCENT 7
2.2.1.7 ALRM ALARMS 8
2.2.1.8 ERASE ERASE DESATURATION 8
2.2.2 SET TIME 8
2.3 LOGBOOK 8
2.4 DIVE PLANNER 8
2.5 PC 8
2.6 INFO 8
3 DIVING WITH PUCK PRO 8
3.1 A FEW WORDS ABOUT NITROX 8
3.2 ALARMS 9
3.2.1 ASCENT RATE 9
3.2.2 MOD/PPO
2
9
3.2.3 CNS = 100% 9
3.2.4 MISSED DECOMPRESSION STOP 9
3.2.4.1 MISSED DECO STOP MODE 10
3.2.5 LOW BATTERY 10
3.3 DISPLAY INFORMATION 10
3.4 AFTER THE DIVE 10
3.5 DIVING WITH MORE THAN ONE GAS MIXTURE 11
3.5.1 SETTING MORE THAN ONE GAS 11
3.5.2 SWITCHING GAS 11
3.5.3 SPECIAL SITUATIONS 12
3.5.3.1 SWITCHING BACK TO A GAS MIXTURE WITH
LOWER OXYGEN CONCENTRATION 12
3.5.3.2 SUBMERGING BELOW THE MOD AFTER A GAS
SWITCH 12
3.6 BOTTOM TIMER MODE 12
3.6.1 DIVE VIOLATION INDUCED BOTTOM TIMER MODE 12
4 TAKING CARE OF PUCK PRO 12
4.1 TECHNICAL INFORMATION 12
4.2 MAINTENANCE 12
4.2.1 REPLACING THE BATTERY IN PUCK PRO 12
4.3 WARRANTY 13
4.4 WARRANTY EXCLUSIONS 13
4.5 HOW TO FIND THE PRODUCT SERIAL NUMBER 13
5 DISPOSAL OF THE DEVICE 13