0504
1a 1b
2
3
4
5
WE ALSO RECOMMEND YOU TO BUY THE
SINGLE FUNCTION SHOWER HEAD
MAREY BRAND
MANERA CORRECTA
CORRECT WAY
MANERA INCORRECTA
WRONG WAY
AGUA CALIENTE / HOT WATER
AGUA FRÍA / COLD WATER
1. Wrap with teflon:
a) Both ends of a ½" straight nipple (not included);
b)The threads on the heater output.
2. Screw one end of the nipple into the back of the heater.
3. Screw the heater onto the pipe, holding the heater cover firmly. Tighten the heater
with an adjustable wrench.
4. Screw on the shower head.
EXTREMELY IMPORTANT!! DO NOT CONNECTPOWER BEFORE ALLOWING
WATER TO FLOW THROUGH THE SHOWER HEATER FOR 10 SECONDS OR
LONGER. DAMAGE MAY OCCUR TO THE UNIT WHICH COULD INVALIDATE
THE WARRANTY.
Turn faucet on and allow the water run for 10 seconds, then attach the shower head.
Note: Only use the shower head included with this Marey® Heater.
Damage may occur if a replacement head is installed and this could also void your
warranty.
5. Plug the heater to a receptacle* 6 feet away from the shower area.
*30 amp electric circuit for exclusive use of the heater. DO NOT USE
EXTENSIONS.
CONGRATULATIONS INSTALLATION IS NOW COMPLETE!
Once the faucet is turned on, hot water will come out instantly.
AQUAMATIC: SET THE TEMPERATURE BY REGULATING THE FLOW OF
WATER AND/OR BY USING THE TEMPERATURE SWITCH AT THE SIDE OF THE
UNIT.
I - LOW (Summer)
II - HIGH (Winter)
To Next Page
Loading...
