Why is the water from my Marey 26HW70 A not hot enough?
If your Marey Water Heater isn't producing hot enough water, you can start by checking for cross-plumbing between your cold and hot water lines. Also, verify that the gas supply valve is fully open. Ensure that the gas line is properly sized and that the gas supply pressure is adequate. Finally, check if the set temperature is set too low.
What to do if hot water is not available when I open a fixture with my Marey 26HW70 A?
If you're not getting any hot water from your Marey Water Heater when you open a fixture, first ensure the unit has a 110V 60Hz power supply. If you're using a remote controller, check if the power button is turned on. Also, make sure the gas and water supply valves are fully open. Check if the filter on the cold water inlet is clean and if you're using propane, ensure there is enough LPG in the bottle.
Why does the hot water from my Marey Water Heater get cold and stay cold?
If the hot water from your Marey Water Heater gets cold and stays cold, make sure the flow rate is sufficient to keep the water heater running. Check that the gas supply valve is fully open and the filter on the cold water inlet is clean. Also, ensure that your fixtures are free of debris and obstructions.
General| Brand | Marey |
|---|---|
| Model | 26HW70 A |
| Category | Water Heater |
| Language | English |
Details installation regulations and codes.
Outlines service and troubleshooting guidelines.
Recommends annual flushing and maintenance.
Provides instructions for hot water outlet connection and pipe sizing.
Warns about dangerous hot water temperatures and how to prevent burns.
Illustrates key components and their functions.
Details the sequence of operations when using the water heater.
Provides detailed diagrams of the unit's dimensions and connection points.
Covers crucial safety warnings, including professional installation, outdoor use, and child supervision.
Covers ventilation, location planning, and checks before installation.
Lists actions that are forbidden to prevent hazards.
Lists technical data and dimensions for the unit.
Ensures correct unit for application.
Advises on outdoor installation, ventilation, and clearances.
Specifies required clearances for outdoor installation and prohibited locations.
Describes the procedure for mounting the water heater on the wall.
Illustrates the gas inlet and gas valve connection points.
Ensures proper gas and water input.
Details steps for checking gas pressure and detecting leaks.
Explains requirements for potable water system components and connections.
Details installation and important considerations for the pressure relief valve.
Provides a visual representation of the unit's electrical connections.
Details grounding, power supply requirements, and servicing precautions.
Explains the automatic drainage function and precautions.
Outlines post-installation checks for leaks and ignition.
Explains priority function, default settings, and self-diagnostic features.
Specifies requirements for splash resistance and installation location.
Details how to connect the remote controller cable and mount it.
Provides step-by-step instructions for wiring the remote controller.
Lists essential safety checks before initial operation.
Provides a step-by-step guide to start the water heater.
Details how to operate the unit with multiple remote controllers.
Warns about freezing conditions and how to protect the unit.
Provides instructions for draining the unit and cleaning the filter.
Offers solutions for common issues with water temperature and availability.
Lists common problems with the remote controller and their solutions.
Explains error codes displayed by the PCB and their handling methods.
Lists conditions that might seem like faults but are normal operations.
Shows different temperature settings available for the 70°C mode.
To Next Page
