16
4.5 WATER HEATER INSTALLATION
①. According to the requirements of the gure and
the size of the water heater, mark the wall with a
dash mark, then drill three holes with a diameter of
¢8mm and a depth of 60mm, respectively insert
three M6×50mm expansion screws into the hole
and tight the expansion screws with a wrench.
②. Hang up the water heater, screw on the M6nut,
and x the water heater to the wall;
③. The installation of the water heater must be
correct, otherwise it will affect the normal use of
the water heater;
4.6 GAS CONNECTION
POWER CORD
To Next Page
Loading...
