20
4.11 WIRING DIAGRAM
4.12 ELECTRICAL CONNECTION
- The water heater must be electrically grounded. Do not attach the ground wire to either the gas or
water piping.
- The water heater requires an AC 110V 60Hz.
- The weather-proof power point should be no more than 1 meter from the base of the water heater for
easy access.
- Install a power switch so that the electrical power can be switched off if necessary.
- If the cord supplied with this appliance must be replaced, it must be replaced with the correct
appliance wiring material supplied by the Manufacturer.
- When servicing or replacing parts within the water heater, label all wires prior to disconnection to
facilitate an easy and error free reconnection. Verify proper operation after servicing.
Do not reverse the hot outlet and cold supply line connections to the water heater as this will cause
your heater to operate improperly.
WARNING
To Next Page
Loading...
