How to fix a Marey POWER PAK Water Heater that is not heating?
If your Marey water heater isn't heating, double-check the wiring to ensure it's correct and that all connections are secure. Also, make sure there is sufficient water flow to engage the unit (9 PSI).
What to do if my Marey POWER PAK starts hot then shuts off?
The overheat sensor is likely shutting your Marey water heater off. Try increasing the water flow or decreasing the heat setting.
How to make my Marey Water Heater produce hotter water?
If your Marey water heater isn't producing water that's warm enough, consider these steps: If a smaller breaker is in use, increase the breaker size to 40 Amps. Turn the heating dial to the maximum setting. Also, reduce the amount of water flowing through the unit.
Why does my Marey POWER PAK Water Heater keep tripping the breaker?
If the breaker is tripping, double-check the wiring to make sure it's correct and that all connections are secure. Also, make sure the heating dial isn't set too high.
General| Brand | Marey |
|---|---|
| Model | POWER PAK |
| Category | Water Heater |
| Language | English |
To Next Page
