Marey POWER PAK - Operating Instructions; Energy Saving Tips; Spare Parts

12
The water temperature is altered by increasing or decreasing the ow rate of the water
through the water heater, via the temperature control knob. Increased amperage
settings will result in increased water temperature.
NOTE: If water pressure is low, the inlet pipe of the water should be ¾" with outputs of
5/8".
Small drop:
Lower water outow. Warmer water.
Big drop:
Higher water outow. Less hot
water.
OPERATING INSTRUCTIONS
The heater should be installed as close as possible to the point of use to avoid heat
loss. If longer distances are required, hot water pipes should be insulated.
Adjust heater temperature settings (located on the front panel of the heater) to the
desired output temperature. Lowering the power setting will save energy, but hot
water temperature will decrease.
We recommend that you install the unit under the sink in the main bathrooms or
utility areas. This will allow for lower amperage usage and a reduced heat loss from
long pipe runs.
For additional savings, reduce the water ow valve at the inlet of the heater so the
ENERGY SAVlNG TlPS
The following comprehensive list of spare parts is available for your Power Pak Plus.
DO NOT REPLACE WITH PARTS NOT RECOMMENDED BY MAREY, AS THIS WILL INVALI-
DATE YOUR WARRANTY AND MAY RENDER THE INSTALLATION DANGEROUS.
Description:
- THERMOSTAT
- SAFESTY VALVE
- HEATING ELEMENT CONTAINER
- MICROSWITCH
- WATER VALVE
ENERGY SAVlNG TlPS