14
5. There are two cable entry points. You can choose one of them and the back plate
will have to be cut out.
6. It is essential that this appliance is connected to a ground.
PLUMBING
7. Use stainless steel exible hose or copper tubing of ½" on the inlet and outlet
pipes.
The pressure relief device is designed into the water heater. The device will work
automatically, when excessive build up of pressure occurs. Do not replace the
pressure relief device with any other screw.
The unit is built of reproof material.
There is a safety thermal cut-out device in the water heater. This thermostat will cut o
electricity to prevent scalding, when there is a sudden rise in water temperature, this
protecting the user.
All models can be tted with Leakage Circuit Breaker (optional).
It is important to keep the showerhead clean in order to maintain the performance of
the water heater.
*Temperature increases listed are based on use of the water heater under optimal
conditions with an incoming water temperature of 48° F. Variable factors such as
incorrect or imperfect installation or warmer incoming water temperature may yield
dierent results.
SPEClAL EQUlPMENT AND ADVlCE TO USERS
TEMPERATURE CHART INCREASER PER GPM*
PP110 GPM
0.8
1.0
-
-
38°F
30°F
-
-
Temp. Increase
per GPM
PPEX5 GPM
0.8
1.0
1.5
1.9
75°F
60°F
40°F
32°F
Temp. Increase
per GPM
To Next Page
Loading...
Need help?
General
