1. WATER HEATER - QTY 1
2. OPERATING INSTRUCTIONS - QTY 1
3. MOUNTING SCREWS - 4 SETS
TECHNICAL SPECIFICATIONS
05
WARNING
If your water heater requires a reset, be sure to TURN OFF THE BREAKERS prior to
resetting the unit.
Resetting your unit without turning o the breakers can result in personal injury and
damage to your water heater.
WARNING! There is water contained in the coils of your water heater at all times. If
your water heater is exposed to freezing temperatures, the water in the coils could
freeze, causing a break in the heat exchanger of the unit, or the supply and return
lines. This kind of damage will result in water running freely into the space where the
water heater is located, which can cause ooding. DO NOT install this water heater
where it may be subjected to a freeze. If your water heater is in an area where freezing
is a possibility, you must turn o the water to the heater and drain it of any water by
disconnecting the water lines. Leave the water lines disconnected until you intend to
PACK CONTENTS
Voltage
Power
Max. Flow Rate
Points of Use
Recommended Wire Size
Activation Flow
Safe Operating Pressure
Water Connections
Frequency
Amperage
Water Pressure
Master Place Cover
Dimensions
Weight
Standard and Approvals
PRODUCT CODE PP110 PP220
(PPEX5)
8 AWG
0.66 GPM
8 PSI - 90 PSI
½" NPT
50 - 60 Hz
10 - 40 A
0.55 Bar
(8PSI) - 6.37 Bar (92.36PSI)
ABS Heating Elements
Copper
11.1" X 10.2" X 4.8"
7 lbs
110V
1.1kW - 4.4kW
1.0 GPM
One
220V
2.2kW - 4.4kW
1.9 GPM
Multiple
4-in-1 AMP
(10, 20, 30 or 40)
AMP AMP
AMP
40 AMP
Breaker
PP110
PP220
KW
4.4kW
Power
6ft Distance
Point of Use
MAX
One Point
of Use
V
110V
KW
8.8kW
Power
40ft Distance
Point of Use
MAX
Multiple
Points of Use
V
220V
To Next Page
Loading...
Need help?
General
